3
10.04
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
3.11 Inserting G code into the sequential control program
Graphical display of the programmed sine path
In the machining plan of a sequential control program, position the
cursor on the program block after which you want to insert a G
code block.
Press the "Input" key.
Enter the G code commands or comments.
The comment must always start with a semicolon (;).
The newly created G code block is marked with a "G" in front of the
block number in the machining plan.
G code in sequential control program
Programming with ShopMill
3
3-315