Editing Part Program Blocks; Selecting G Blocks - Siemens SINUMERIK 840D Operation/Programming Manual

5
Simulation

5.12 Editing part program blocks

5.12

Editing part program blocks

5.12.1 Selecting G blocks

Searching via a string
Edit Search
Search
Searching via a block
number
Go to
Edit
OK
Jumping to start/end
Edit
Beginning End of
of program program
5-344
During quick display, you are automatically in the G code editor. The
program being visualized is open. There are various ways you can
edit the part program shown here.
There are various ways you can get to the block to be edited in the
opened part program either directly or via a search function.
Press the "Edit " and "Search" softkeys.
The "Search from cursor position" window opens.
Enter a string in the "Search:" input field.
Press the "Search" softkey.
The search starts.
If a matching block is found, it is color-highlighted in the program
section.
Press the "Edit " and "Go to" softkeys.
The "Go to ..." window opens.
Enter a G block in the "Block number ..." input field and press the
"OK" softkey.
The search starts.
If the matching block is found, it is displayed color-highlighted in the
program section.
Press the "Edit" and "Beginning of program" or "End of program"
softkeys.
The first or last block of the opened part program is displayed color-
highlighted in the program section.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
5
10.04
 Siemens AG, 2004. All rights reserved