Siemens SINUMERIK 840D Operation/Programming Manual page 332

5
Simulation
5.2 Starting/stopping a program in standard simulation
Details Settings
Stop simulation
Aborting simulation
Resuming simulation
Ending simulation
End
5-332
With a G code program, select the "Details" and "Settings"
softkeys and enter the dimensions of your choice (see also Sec.
"Creating a new program; defining a blank").
These dimensions are stored for simulation of the next G code
program. If you set the "Blank" parameter to "off", the dimensions will
be deleted.
Feedrate override is also active during simulation.
0%: The simulation stops.
≥ 100%: The program is executed as fast as possible.
Feedrate override for simulation must be activated via a machine data
code.
Please refer to the machine manufacturer's instructions.
Press the "Stop" softkey.
Simulation is stopped.
Press the "Reset" softkey.
Simulation is aborted and the unmachined blank shape of the
workpiece is displayed again.
Press "Start" softkey.
Simulation is resumed.
Press the "End" softkey.
The machining plan or programming graphic for the program is
displayed again.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
5
10.04
 Siemens AG, 2004. All rights reserved