Siemens SINUMERIK 840D Operation/Programming Manual page 414

8
Alarms and Messages
8.2 Alarms in ShopMill
112611
Explanation
Response
Remedy
112650
Explanation
Response
Remedy
8-414
NC Start not possible: % Deselect SBL mode
A program was activated with block search, while at the same time
single block was active.
NC Start disable
Interface signals are set
Alarm display
Deselect single block mode.
Unknown PLC error
An error unknown to the user interface has been output by the PLC.
Alarm display
NC Start disable
Press Power ON, inform Siemens.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
8
10.04
 Siemens AG, 2004. All rights reserved