Siemens SINUMERIK 840D Operation/Programming Manual page 340

5
Simulation
5.8 Views in the quick display
Changing the orientation
in 3D
Details
Rotate
Up
Down
Left
Right
Accept
5-340
You can rotate the graphics in the X, Y, or Z axis direction.
Press the "Details" and "Rotate" softkeys.
Press the "Up" softkey.
- OR -
Press the "Down" softkey.
- OR -
Press the "Left" softkey.
- OR -
Press the "Right" softkey.
- OR -
Press one of the cursor keys.
You can see the result of the rotate command in the coordinate
system in the lower left corner.
Press the "Accept" softkey.
The commands are applied and the visualized workpiece is shown
with its new axis orientation.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
5
10.04
 Siemens AG, 2004. All rights reserved