2
10.04
Select other ShopMill
block or G code block
To
External -
endpoint
without cal.
...
Cycle Start
Cycle Start
Reset
Search
pointer
Interr.
point
To
External -
endpoint
without cal.
...
Cycle Start
Cycle Start
Reset
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
Position cursor on target block
Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Position the cursor on the desired target block.
Press the "Block search" softkey.
Select a calculation technique.
Press the "Cycle Start" key.
ShopMill carries out all necessary default settings.
Press the "Cycle Start" key again.
The new starting position is approached. The program executes from
the beginning or end of the target block, depending on the calculation
technique.
You can abort the search by pressing the "Reset" key.
Select point of interruption
Program execution must have been interrupted by pressing the
"Reset" key. (ShopMill automatically remembers this point of
interruption.)
Switch back to "Machine Auto" mode.
Press the "Block search" and "Search pointer" softkeys.
Press the "Interr. point" softkey.
ShopMill inserts the saved point of interruption as the target.
Select a calculation technique.
Press the "Cycle Start" key.
ShopMill carries out all necessary default settings.
Press the "Cycle Start" key again.
The new starting position is approached. The program executes from
the beginning or end of the target block, depending on the calculation
technique.
You can abort the search by pressing the "Reset" key.
Operation
2.10 Automatic mode
2
2-123