8
10.04
62181
62182
62183
62184
62185
8.1.3 Messages in the cycles
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
"Set rotary axis ... "
"Attach inclinable head: ..."
"Remove inclinable head:..."
"Replace inclinable head:..."
"Angle adjusted to angular grid:..." Indication that the desired angle cannot be set
The cycles output messages in the dialog line of the control. These
messages do not interrupt execution.
They provide information about specific cycle behavior and how
machining is progressing and are usually displayed for the duration of
the machining operation or until the end of the cycle.
8.1 Cycle alarms and messages
Prompt to position rotary axis manually.
Request to load a swivel head.
Prompt to remove inclinable head.
Prompt to replace inclinable head.
due to the Hirth tooth system. The displayed
angle is set instead.
8
Alarms and Messages
8-403