Siemens SINUMERIK 840D Operation/Programming Manual page 401

8
10.04
61203
61204
61205
61210
61212
61213
61214
61215
61216
61217
61218
61222
61223
61224
61225
61226
61230
61231
61232
61234
61301
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
"Not a position cycle"
"Unknown technology cycle"
"Unknown position cycle"
"Block search element not found" Repeat block search.
"Incorrect tool type"
"Circle radius too small"
"No pitch programmed"
"Blank dimension incorrectly
programmed"
"Feed/tooth possible only for
milling tools"
"Cutting rate programmed for tool
radius 0"
"Feed/tooth programmed, but
number of teeth is zero"
"Plane infeed greater than tool
diameter"
"Approach path too small"
"Retract path too small"
"Swiveling data block unknown"
"Swivel head cannot be replaced" The parameter "Swivel data block" is set to
"Tool probe diameter too small"
"Sequential control program
cannot be executed; not yet tested
by ShopMill"
"Magazine tool cannot be loaded" Only manual tools may be loaded into a swivel
"ShopMill subroutine cannot be
executed; not yet tested by
ShopMill"
"Probe is not responding"
8.1 Cycle alarms and messages
Program positioning block.
Delete and reprogram technology block.
Delete and reprogram positioning block.
Select a new tool type.
Enter a larger value for the circle radius.
The pitch must be programmed
Check dimensions of blank spigot. The blank
spigot must be larger than the finished spigot.
Alternatively, you can set another feed type
Enter a cutting rate setting.
Enter the number of teeth of the cutting tool in
the "Tool list" menu.
Reduce plane infeed.
Enter a larger value for the approach path.
Enter a larger value for the retract path.
An attempt was made to access a swivel data
block which has not been defined.
"No". In spite of this, an attempt has been made
to change the swivel head.
The tool probe is not correctly calibrated.
The program has to be simulated first in
ShopMill or loaded into the operating mode
"Machine auto" by ShopMill.
head in which the tools can only be manually
loaded.
The subroutine has to be simulated first in
ShopMill or loaded into the ShopMill operating
mode "Machine auto".
• Check probe connection
• Set a longer measuring distance via
MD 9752, 9753, 9754, 9755
• For edge measurements: Position probe
closer to edge
• For spigots/holes: Position roughly over the
middle
• Check value for spigot/hole diameter
8
Alarms and Messages
8-401