Siemens SINUMERIK 840D Operation/Programming Manual page 413

8
10.04
112542
Explanation
Response
Remedy
112543
Explanation
Response
Remedy
112544
Explanation
Response
Remedy
112546
Explanation
Response
Remedy
112550
Explanation
Response
Remedy
112604
Explanation
Response
Remedy
112605
Note
Response
Remedy
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
GUD variable not available or too small in the field dimension:
%1
The required GUD variable was not found during read or write access.
Alarm display
Include the right GUD variables.
Prog. was created with higher software version
The part program was created with a higher software version than the
existing software version.
Alarm display
Delete the machining operation and, if necessary, program it
elsewhere.
Program cannot be opened. It is already being edited.
The program is already opened in another editor (e.g. in HMI
Advanced).
Alarm display
Close the program
Program cannot be opened. No read rights on file.
The file has no read rights for the current access level.
Alarm display
Set the read rights by means of keyswitch or password entry.
Sequential control programming not opened
The "sequential control programming" option has not been set.
Alarm display
The program is opened as G code.
Buy option.
Connection to PLC broken
Acknowledgement to the PLC user program, that the connection with
the PCU has been broken off.
Alarm display
ShopMill PLC is shut down
Check PLC user program.
Asynchronous subroutine has not been executed
Input values could not be processed correctly by the NC.
Alarm display
Perform NC reset.
Alarms and Messages
8.2 Alarms in ShopMill
8
8-413