Main Menu - Smart Logic - Group - Danfoss VLT HVAC Series Programming Manual

3 Parameter Description
11-21 Store Data Values
Option:
[0] * Off
[2] Store all setups
3

3.13 Main Menu - Smart Logic - Group 13

3.13.1 13-** Prog. Features Prog. Features
Smart Logic Control (SLC) is essentially a sequence of user defined actions (see par.13-52
associated user defined event
together in pairs. This means that when
be evaluated and if evaluated TRUE,
FALSE, nothing happens (in the SLC) during the current scan interval and no other
event
evaluates [0] (and only
event [1]. It is possible to program from 1 to 20
When the last event / action
events/actions:
Starting and stopping the SLC:
Starting and stopping the SLC can be done by selecting
event
evaluates [0]). The SLC starts when the start event (defined in par.13-01
SL Controller Mode
par.13-00
starts programming from scratch.
3-118
Function:
This parameter is used to activate storing of data in non-volatile memory.
Store function is inactive.
Stores all parameter values in the EEPROM. The value returns to
been stored.
(see par.13-51 SL Controller Event [x]) is evaluated as TRUE by the SLC. Events and
event
[0] is fulfilled (attains the value TRUE),
action
[1] will be executed and so on. Only one
event
[0]) each scan interval. Only when
events and actions
has been executed, the sequence starts over again from
On [1] or
Stop Event
). The SLC stops when the
MG.11.C6.22 - VLT
SL Controller Action
action
[0] is executed. After this, the conditions of
event
will be evaluated at any time. If an
events
will be evaluated. This means that when the SLC starts, it
event
[0] is evaluated TRUE, will the SLC execute
.
event [0] / action [0]. The illustration shows an example with three
Off [0] in par.13-00 SL Controller Mode
Start Event
) is evaluated as TRUE (provided that
Stop Event
(par.13-02 ) is TRUE. par.13-03
® is a registered Danfoss trademark
VLT ® HVAC Drive Programming Guide
Off
when all parameter values have
[x]) executed by the SLC when the
actions are each numbered and linked
event
event
is evaluated as
action
[0] and start evaluating
. The SLC always starts in state 0 (where it
On
[1] is selected in
Reset SLC
resets all SLC parameters and
[1] will