Table of Contents
Advertisement
3 Parameter Description
8-81 Bus Error Count
Range:
0 N/A*
[0 - 0 N/A]
8-82 Slave Message Count
Range:
0 N/A*
[0 - 0 N/A]
3
8-83 Slave Error Count
Range:
0 N/A*
[0 - 0 N/A]
3.9.8 8-9* Bus Jog
Parameters for configuring the Bus Jog.
8-90 Bus Jog 1 Speed
Range:
100 RPM*
[0 - par. 4-13 RPM]
8-91 Bus Jog 2 Speed
Range:
200 RPM*
[0 - par. 4-13 RPM]
8-94 Bus Feedback 1
Range:
0 N/A*
[-200 - 200 N/A]
8-95 Bus Feedback 2
Range:
0 N/A*
[-200 - 200 N/A]
8-96 Bus Feedback 3
Range:
0 N/A*
[-200 - 200 N/A]
3-100
Function:
This parameter shows the number of messages with faults (e.g., CRC fault), detected on the bus.
Function:
This parameter shows the number of valid messages addressed to the slave, sent by the adjustable
frequency drive.
Function:
This parameter shows the number of error messages, which could not be executed by the adjustable
frequency drive.
Function:
Enter the jog speed. This is a fixed jog speed activated via the serial port or serial communication
bus option.
Function:
Enter the jog speed. This is a fixed jog speed activated via the serial port or serial communication
bus option.
Function:
Write a feedback to this parameter via the serial communication port or serial communication bus
option. This parameter must be selected in par.20-00
Source
or par.20-06
Feedback 3 Source
Function:
Bus Feedback 1
See par.8-94
for further details.
Function:
See par.8-94
Bus Feedback 1
for further details.
MG.11.C6.22 - VLT
®
is a registered Danfoss trademark
VLT
®
HVAC Drive Programming Guide
Feedback 1 Source
, par.20-03
as a feedback source.
Feedback 2
Advertisement
Table of Contents
