Table of Contents
Advertisement
3 Parameter Description
3.20.5 22-6* Broken Belt Detection
Broken belt detection can be used in both closed-loop and open-loop systems for pumps, fans and compressors. If the estimated motor torque is below
the broken belt torque value (par.22-61
Broken Belt Function
belt function (par.22-60
22-60 Broken Belt Function
3
Option:
[0] *
OFF
[1]
Warning
[2]
Trip
22-61 Broken Belt Torque
Range:
10 %*
[0 - 100 %]
22-62 Broken Belt Delay
Range:
10 s
[0 - 600 s]
3.20.6 22-7* Short Cycle Protection
When controlling refrigeration compressors, often there will be a need for limiting the numbers of starts. One way to do this is to ensure a minimum run
time (time between a start and a stop) and a minimum interval between starts.
This means that any normal stop command can be overridden by the
command (Start/Jog/Freeze) can be overridden by the
None of the two functions are active if
to 0, and not start counting until
NOTE!
A Coast command or missing Run Permissive signal will override both Minimum Run Time and Interval Between Starts functions.
22-75 Short Cycle Protection
Option:
[0] *
Disabled
[1]
Enabled
22-76 Interval between Starts
Range:
par. 22-77
[par. 22-77 - 3600 s]
s*
3-206
Broken Belt Torque
) and the adjustable frequency drive output frequency is above or equal to 15 Hz, the broken
) is performed.
Function:
Selects the action to be performed if the broken belt condition is detected.
Function:
Sets the broken belt torque as a percentage of the rated motor torque.
Function:
Sets the time for which the broken belt conditions must be active before carrying out the action
selected in par.22-60
Minimum Run Time
Interval Between Starts
Hand On
or
Off
modes have been activated via the LCP. If selecting
Auto
is pressed and an active start command applied.
Function:
Timer set in par.22-76
Timer set in par.22-76
Function:
Sets the time desired as minimum time between two starts. Any normal start command (Start/Jog/
Freeze) will be disregarded until the timer has expired.
MG.11.C6.22 - VLT
VLT
Broken Belt Function
.
Minimum Run Time
function (par.22-77
function (par.22-76
Interval between Starts
Hand On
Interval between Starts
is disabled.
Interval between Starts
is enabled.
®
is a registered Danfoss trademark
®
HVAC Drive Programming Guide
) and any normal start
).
or
Off
, the two timers will be reset
Advertisement
Table of Contents
