Danfoss VLT HVAC Series Programming Manual page 140

3 Parameter Description
10-31 Store Data Values
Option:
[0] * Off
[1] Store edit setup
3
[2] Store all setups
10-32 Devicenet Revision
Range:
0 N/A* [0 - 65535 N/A]
10-33 Store Always
Option:
[0] * Off
[1] On
10-39 Devicenet F Parameters
Array [1000]
No LCP access
Range:
0 N/A* [0 - 0 N/A]
3-116
Function:
Parameter values changed via DeviceNet are not automatically stored in non-volatile memory. Use
this parameter to activate a function that stores parameter values in the EEPROM non-volatile
memory, so that changed parameter values will be retained at power-down.
Deactivates the non-volatile storage function.
Stores all parameter values from the active set-up in the non-volatile memory. The selection returns
to Off [0] when all values have been stored.
Stores all parameter values for all set-ups in the non-volatile memory. The selection returns to
Off
[0] when all parameter values have been stored.
Function:
View the DeviceNet revision number. This parameter is used for EDS file creation.
Function:
Deactivates non-volatile storage of data.
Stores parameter data received via DeviceNet in EEProm non-volatile memory as default.
Function:
This parameter is used to configure the adjustable frequency drive via DeviceNet and build the EDS
file.
MG.11.C6.22 - VLT ® is a registered Danfoss trademark
VLT ® HVAC Drive Programming Guide