Danfoss VLT HVAC Series Programming Manual page 21

VLT ® HVAC Drive Programming Guide
2.1.8 Parameter Selection
In main menu mode, the parameters are divided into groups. You select
a parameter group by means of the navigation keys.
The following parameter groups are accessible:
After selecting a parameter group, choose a parameter by means of the
navigation keys.
The middle section on the display shows the parameter number and name
as well as the selected parameter value.
2.1.9 Changing Data
The procedure for changing data is the same whether you select a parameter in the quick menu or the main menu mode. Press [OK] to change the
selected parameter.
The procedure for changing data depends on whether the selected parameter represents a numerical data value or a text value.
2.1.10 Changing a Text Value
If the selected parameter is a text value, change the text value by means
▲ ▼
of the [ ] [ ] navigation keys.
The up key increases the value, and the down key decreases the value.
Place the cursor on the value you want to save and press [OK].
Group no.
0
1
2
3
4
5
6
8
9
10
11
13
14
15
16
18
20
21
22
23
25
26
MG.11.C6.22 - VLT ® is a registered Danfoss trademark
2 How to Program
Parameter group:
Operation/Display
Load/Motor
Brakes
References/Ramps
Limits/Warnings
Digital In/Out
Analog In/Out
Comm. and Options
Profibus
CAN Ser. Com. Bus
LonWorks
Smart Logic
Special Functions
Adjustable Frequency Drive Information
Data Readouts
Data Readouts 2
Drive Closed-loop
Ext. Closed-loop
Application Functions
Time-based Functions
Cascade Controller
Analog I/O Option MCB 109
2
2-17