Danfoss VLT HVAC Series Programming Manual page 176

3 Parameter Description
16-05 Main Actual Value [%]
Range:
0.00 %* [-100.00 - 100.00 %]
16-09 Custom Readout
Range:
0.00 Cus- [-999999.99 - 999999.99 Custom-
3
tomReadou- ReadoutUnit]
tUnit*
3.16.3 16-1* Motor Status
Parameters for reading the motor status values.
16-10 Power [kW]
Range:
0.00 kW* [0.00 - 1000.00 kW]
16-11 Power [hp]
Range:
0.00 hp* [0.00 - 1000.00 hp]
16-12 Motor voltage
Range:
0.0 V* [0.0 - 6000.0 V]
16-13 Frequency
Range:
0.0 Hz* [0.0 - 6500.0 Hz]
16-14 Motor Current
Range:
0.00 A* [0.00 - 1856.00 A]
16-15 Frequency [%]
Range:
0.00 %* [-100.00 - 100.00 %]
3-152
Function:
View the two-byte word sent with the status word to the bus master reporting the main actual value.
Function:
View the user-defined readouts as defined in par.0-30
Readout Min Value Custom Readout Max Value
and par.0-32
Function:
View the motor power in kW. The value shown is calculated on the basis of the actual motor voltage
and motor current. The value is filtered, and therefore approx. 30 ms may pass from when an input
value changes to when the data readout values change.
Function:
View the motor power in HP. The value shown is calculated on the basis of the actual motor voltage
and motor current. The value is filtered, and therefore approximately 30 ms may pass from when
an input value changes to when the data readout values change.
Function:
View the motor voltage, a calculated value used for controlling the motor.
Function:
View the motor frequency, without resonance dampening.
Function:
View the motor current measured as a mean value, IRMS. The value is filtered, and thus approxi-
mately 30 ms may pass from when an input value changes to when the data readout values change.
Function:
MG.11.C6.22 - VLT ® is a registered Danfoss trademark
VLT ® HVAC Drive Programming Guide
Custom Readout Unit
, par.0-31
.
Custom