Danfoss VLT HVAC Series Programming Manual page 41

VLT ® HVAC Drive Programming Guide
0-72 Time Format
Option:
[0] * 24 h
[1] 12 h
0-74 DST/Summertime
Option:
[0] * OFF
[2] Manual
0-76 DST/Summertime Start
Range:
0 N/A* [0 - 0 N/A]
0-77 DST/Summertime End
Range:
0 N/A* [0 - 0 N/A]
0-79 Clock Fault
Option:
[0] * Disabled
[1] Enabled
0-81 Working Days
Array with 7 elements [0] - [6] displayed below parameter number in display. Press OK and step between elements by means of
the LCP.
Option:
[0] * No
[1] Yes
0-82 Additional Working Days
Array with 5 elements [0] - [4] displayed below parameter number in display. Press OK and step between elements by means of
the LCP.
Range:
0 N/A* [0 - 0 N/A]
Function:
Sets the time format to be used in the LCP.
Function:
Choose how Daylight Saving Time/Summertime should be handled. For manual DST/Summertime
enter the start date and end date in par.0-76
End
.
Function:
Sets the date and time when summertime/DST starts. The date is programmed in the format se-
Date Format
lected in par.0-71 .
Function:
Sets the date and time when summertime/DST ends. The date is programmed in the format selected
Date Format
in par.0-71 .
Function:
Enables or disables the clock warning when the clock has not been set, or has been reset due to a
power-down and no backup is installed.
Function:
Specify whether each weekday is a workday or a non-workday. First element of the array is Monday.
The workdays are used for timed actions.
Function:
Defines dates for additional working days that normally would be non-working days according to
Additional Working Days
par.0-82
MG.11.C6.22 - VLT ® is a registered Danfoss trademark
DST/Summertime Start and par.0-77
.
3 Parameter Description
3
DST/Summertime
▲ ▼
and buttons on
▲ ▼
and buttons on
3-17