Danfoss VLT HVAC Series Programming Manual page 102

3 Parameter Description
5-63 Terminal 29 Pulse Output Variable
Option:
[0] * No operation
[45] Bus ctrl.
[48] Bus ctrl., timeout
[100] Output frequency
3
[101] Reference
[102] Feedback
[103] Motor current
[104] Torque rel to limit
[105] Torq relate to rated
[106] Power
[107] Speed
[113] Ext. Closed-loop 1
[114] Ext. Closed-loop 2
[115] Ext. Closed-loop 3
5-65 Pulse Output Max Freq #29
Range:
5000 Hz* [0 - 32000 Hz]
5-66 Terminal X30/6 Pulse Output Variable
Option:
[0] * No operation
[45] Bus ctrl.
[48] Bus ctrl., timeout
[100] Output frequency
[101] Reference
[102] Feedback
[103] Motor current
[104] Torque rel to limit
[105] Torq relate to rated
[106] Power
[107] Speed
[113] Ext. Closed-loop 1
[114] Ext. Closed-loop 2
[115] Ext. Closed-loop 3
3-78
Function:
Select the variable for viewing on the terminal 29 display.
This parameter cannot be adjusted while the motor is running.
Function:
Set the maximum frequency for terminal 29 corresponding to the output variable set in par.
Terminal 29 Pulse Output Variable
5-63
This parameter cannot be adjusted while the motor is running.
Function:
Select the variable for readout on terminal X30/6.
This parameter cannot be adjusted while the motor is running.
This parameter is active when option module MCB 101 is installed in the adjustable frequency drive.
MG.11.C6.22 - VLT ® is a registered Danfoss trademark
VLT ® HVAC Drive Programming Guide
.