Configuration And Parameterization With Wago-I/O-Check - WAGO 750-564 Manual

WAGO-I/O-SYSTEM 750
750-564 4AO U/I
7.1 Configuration and Parameterization with
WAGO-I/O-CHECK
The I/O Module 750-564 is supported by the WAGO-I/O-CHECK commissioning
tool staring with version 03.21.01(01).
WAGO-I/O-CHECK can be used to conveniently and completely configure and
parameterize the I/O module. You have the following options:
• Graphical representation of the fieldbus node
• Display of the measured values
• Settings for the application
• Configuration of the I/O module operating modes
• Parameterization of module, channel and scaling settings
• Calibration of channels and adjustment of analog outputs
• Monitoring
WAGO-I/O-CHECK
You can obtain the WAGO-I/O-CHECK software on a CD under Item No.
759-302. This CD contains all the application program files and an explanation.
You can find a description on the website at
Save all your settings before you begin parameterization!
To be on the safe side, you should always save all of your current settings in a
parameter file before you begin parameterization. This allows you to always use
the original values should the parameterization be incorrect.
To configure the I/O module with WAGO-I/O-CHECK, proceed as follows:
1. Open WAGO-I/O-CHECK.
2. Left-click on the menu item [Identify].
The node configuration is determined and displayed.
Commissioning
www.wago.com
59
Manual
Version 1.0.0