To Load Trace Data - HP 64782 User Manual

To load trace data

•
Choose File→Load→Trace Data... In the dialog box, click on the
name of the trace data file (file of trace memory content) you want to
load (placing it in the Load Trace Data box). Then click OK.
•
Using the command line, load trace data from a file by entering:
load trace <filename>
<filename> is any UNIX file name including paths. The extension .TR is
assumed.
Loads a previously saved trace from a binary trace data file (with a ".TR"
suffix).
Once you save trace data in a file using the File→Store→Trace Data... or
store trace command, you can reload it. To view the data you loaded, use
the Display→Trace, Trace→Display, or display trace command.
Remember that a new trace measurement will overwrite this trace data (but
not the file from which it was loaded).
The interface will try to display the trace listing in the display format active
when the trace data was stored. If the interface needs symbols to replace
absolute addresses or to find high-level source lines, and symbols are not
loaded, an error occurs.
For example, suppose "source-mixed" was the display mode when the trace
was captured and the executable file "test1" was the file being executed in
the emulator/target system. To reload and display a trace listing saved from
that emulation session requires reloading the symbols for "test1".
Example Load a trace from a file:
load trace trace1
Using the Emulation Analyzer
To load trace data
253