Step 3: Run From The Transfer Address - HP 64782 User Manual

Getting Started

Step 3: Run from the transfer address

Step 3: Run from the transfer address
The transfer address is the entry address defined by the software
development tools and included with the program's symbol information.
•
Click on the Run Xfer til () action key.
Or, using the command line, enter:
run from transfer_address until main
Figure 4
Notice the message "Software break: <address>" is displayed on the status
line and that the emulator is "Running in monitor" (you may have to click the
select mouse button to remove temporary messages from the status line).
When you run until an address, a breakpoint is set at the address before the
program is run.
Notice the highlighted bar on the screen; it shows the current program
counter.
34