To run programs from an address
•
Position the mouse pointer in the entry buffer and enter the address
you want to run from; then, choose Execution→Run→from ().
•
Using the command line, enter the run from <address> command.
Examples
To run from address 920H:
run from 920h
To run programs from the transfer address
•
Choose Execution→Run→from Transfer Address.
•
Using the command line, enter the run from transfer_address
command.
Most software development tools allow you to specify a starting or entry
address for program execution. That address is included with the absolute
file's symbolic information and is known by the interface as the transfer
address.
To run programs from reset
•
Choose Execution→Run→from Reset.
•
Using the command line, enter the run from reset command.
The run from reset command specifies a run from target system reset. It is
equivalent to entering a reset command followed by a run command. The
processor will be reset and then allowed to run.
Using the Emulator
To run programs from an address
155