Table of Contents
Advertisement
To specify trace disassembly options
•
Selection of disassembly options is not supported in pulldowns of the
Graphical User Interface. By default, the Graphical User Interface
selects high_word and all_cycles. Use the command line if you
need to specify trace disassembly using other options.
•
Using the command line, enter commands as follows:
•
To show only instruction cycles in the trace list, enter:
display trace disassemble_from_line_number
<LINE#> instructions_only
•
To show all bus cycles in the trace list, enter:
display trace disassemble_from_line_number
<LINE#> all_cycles
Normally, the MC6833x presents the trace list data as it was stored by the
analyzer. That is, all bus cycles are shown, and disassembly starts with the
most significant word of the data.
If you don't want to see operand cycles in the trace list, specify the
instructions_only option.
The disassembly options remain in effect until you specify a new disassembly
option.
Note that although the "high_word," "low_word" and "align" options are
displayed, these are for 32-bit processors only, and will not perform any
action.
Using the Emulation Analyzer
To specify trace disassembly options
237
Advertisement
Table of Contents
