Table of Contents
Advertisement
Error Messages
CMB execute; run started (693)
Cause: This status message is displayed when you are making coordinated
measurements. The CMB /EXECUTE pulse has been received; the emulation
processor started running at the address specified by the specify run
command.
Action: None; information only.
CMB execute break (623)
Cause: This message occurs when coordinated measurements are enabled
and an EXECUTE pulse causes the emulator to run; the emulator must break
before running.
Action: This is a status message; no action is required.
CMB trigger break (617)
Cause: This status message will be displayed if you have configured the
emulator to break on a CMB trigger signal and the CMB trigger line is
activated during a program run. The emulator is broken to the monitor.
Command not allowed in ACT mode (156)
Cause: This command is not applicable or is not allowed in ACT mode.
Command not applicable in ACT mode (158)
Cause: This message will appear if you execute an emulator command that
does not apply when the emulator is in ACT mode.
Configuration aborted (624)
Cause: Occurs when a <CTRL>c is entered while emulator configuration
items are being set.
Configuration failed; setting unknown: %s=%s (626)
Cause: Target condition or system failure.
Action: Check target system, and run performance verification (Terminal
Interface pv command).
452
Advertisement
Table of Contents
