Table of Contents
Advertisement
Configuring the Emulator
To display information about the reset mode configuration
To display information about the reset mode
configuration
•
Choose Display→Configuration Info→Reset Mode Value from
either the configuration interface the emulator/analyzer interface
pulldown menu.
•
Using the emulator/analyzer interface command line, enter the
display configuration_info reset_mode command.
Examples
To display information about the reset mode configuration, choose
Display→Configuration Info→Reset Mode Value from either the
configuration interface the emulator/analyzer interface pulldown menu.
The reset mode configuration value will be driven by the emulator.
of 0FFFH was generated automatically by the emulator to be compatible with
the current values in the emsim register set.
if any values in that register set change.
Data Bit
Value
Selects
--------
-----
-------------------
0
1
CSBOOT 16-bit
1
1
CS0, CS1, CS2
2
1
CS3, CS4, CS5
3
1
CS6
4
1
CS7
5
1
CS8
6
1
CS9
7
1
CS10
8
1
Bus Control Lines
9
1
IRQ7-1, MODCK
11
1
Slave Mode Disabled
128
It will be regenerated
Comment
---------------------------
The value
Advertisement
Table of Contents
