Table of Contents
Advertisement
pod_command
Allows you to control the emulator through the direct HP 64700 Terminal
Interface.
The HP 64700 Card Cage contains a low-level Terminal Interface, which
allows you to control the emulator's functions directly. You can access this
interface using pod_command. The options to pod_command allow you
to supply only one command at a time. Or, you can select a keyboard mode
which gives you interactive access to the Terminal Interface.
There are certain commands that you should avoid while using the Terminal
Interface through pod_command.
stty, po, xp
Do not use. These commands will change the operation of
the communications channel, and are likely to hang the
Softkey Interface and the channel.
echo, mac
Using these may confuse the communications protocols in
use on the channel.
wait
Do not use. The pod will enter a wait state, blocking access
by the emulator/analyzer interface.
init, pv
These will reset the emulator pod and force an end
release_system command.
t
Do not use. The trace status polling and unload will become
confused.
To see the results of a particular pod_command (the information returned
by the emulator pod), you use display pod_command.
Refer to the 6833x Emulator User's Guide for the Terminal Interface for
information on using the Terminal Interface to control the emulator.
Emulator/Analyzer Interface Commands
pod_command
403
Advertisement
Table of Contents
