To Change The Column Width - HP 64782 User Manual

Using the Emulation Analyzer

To change the column width

To change the column width
•
Choose Settings→Display Modes..., and select desired widths for
information in the trace list by using the dialog box. Refer to the
"Examples" page under "To display symbols in the trace list", earlier
in this chapter for details of how to use the dialog box.
•
To set the column width for the address column in the trace list,
enter:
set width label <WIDTH>
•
To set the column width for the mnemonic column in the trace list,
enter:
set width mnemonic <WIDTH>
•
To set the column width for source lines in the trace list, enter:
set width source <WIDTH>
<WIDTH> is an integer between 1 and 80, specifying the width of the column
in characters. (<WIDTH> is restricted to certain values which are shown if
you press the <WIDTH> softkey.)
You can display more information by widening a column or ignore the
information by narrowing the column. For example, you might want to widen
the label column so that you can see the complete names of the symbols in
that column.
You can combine multiple options on the command line to set the width for
several columns at once.
244