Table of Contents
Advertisement
Emulator/Analyzer Interface Commands
store
store
This command lets you save the contents of specific memory locations in an
absolute file. You also can save trace memory contents in a trace file.
The store command creates a new file with the name you specify, if there is
not already an absolute file with the same name. If a file represented by
<FILE> already exists, you must decide whether to keep or delete the old
file. If you respond with yes to the prompt, the new file replaces the old one.
If you respond with no, the store command is canceled and no data is stored.
The transfer address of the absolute file is set to zero.
The parameters are as follows:
--EXPR--
This is a combination of numeric values, symbols, operators, and
parentheses, specifying a memory address. See the EXPR syntax diagram.
FCODE
The function code used to define the address space being referenced. See the
syntax diagram for FCODE to see a list of the function codes available and for
an explanation of those codes.
<FILE>
This represents a file name you specify for the absolute file identifier or trace
file where data is to be stored. If you want to name a file beginning with a
number, you must precede the file name with a backslash (\) so the system
will recognize it as a file name.
memory
This causes selected memory locations to be stored in the specified HP64000
format file with a .X extension.
426
Advertisement
Table of Contents
