HP 64782 User Manual page 524

Verifying the Installation
This section shows you how to:
•
Determine the logical name of your emulator.
•
Start the emulator/analyzer interface for the first time.
•
Exit the emulator/analyzer interface.
Step 1. Determine the logical name of your emulator
The logical name of an emulator is a label associated with a set of
communications parameters in the $HP64000/etc/64700tab.net file. The
64700tab.net file is placed in the directory as part of the installation process.
Display the 64700tab.net file by entering
1
more /usr/hp64700/etc/64700tab.net at the HP-UX prompt.
Page through the file until you find the emulator you are going to use.
2
This step will require some matching of information to an emulator, but it
should not be difficult to determine which emulator you want to address.
Examples
A typical entry for a 6833x emulator connected to the LAN would appear as
follows:
#---------------------------------------------------------------------------
# Channel| Logical
# Type | Name
#---------------------------------------------------------------------------
lan: em6833x
A typical entry for a 6833x emulator connected to an RS-422 port would
appear as follows:
#-------------------------------------------------------------------------------
# |
# Channel| Logical
# Type | Name
# |
#-------------------------------------------------------------------------------
serial: em6833x
| Processor | Remainder of Information for the Channel
| Type | (IP address for LAN connections)
m6833x 21.17.9.143
| | |
| Processor | Host |
| Type | Name |
| | |
m6833x myhost /dev/emcom23 OFF
|Xpar|Parity|Flow|Stop|Char
Physical |Mode|
Device | |
|OFF | NONE |RTS | 2
NONE
| |Bits|Size
|XON | |
| 8
RTS 2 8
523