Starting the Emulator/Analyzer Interface
Before starting the emulator/analyzer interface, the emulator and interface
software must have already been installed as described in the "Installation"
chapter.
This section describes how to:
•
Start the interface.
•
Start the interface using the default configuration.
•
Run a command file on interface startup.
•
Display the status of emulators defined in the 64700tab.net file.
•
Unlock an interface that was left locked by another user.
To start the emulator/analyzer interface
•
Use the emul700 <emul_name> command.
If /usr/hp64000/bin is specified in your PATH environment variable (as shown
in the "Installation" chapter), you can start the interface with the emul700
<emul_name> command. The "emul_name" is the logical emulator name
given in the HP 64700 emulator device table (/usr/hp64000/etc/64700tab.net).
It may also be the LAN address.
If you are running a window system on your host computer (for example, the
X Window System), you can run the interface in up to 10 windows. This
capability provides you with several views into the emulation system. For
example, you can display memory in one window, registers in another, an
analyzer trace in a third, and data in the fourth.
55