Sequencing - HP 64782 User Manual

For the graphical user interface

Hide thumbs Also See for 64782:

Table of Contents

Emulator/Analyzer Interface Commands

SEQUENCING

Lets you specify complex branching activity that must be satisfied to trigger

the analyzer.

Sequencing provides you with parameters for the trace command that let

you define branching conditions for the analyzer trigger.

You are limited to a total of seven sequence terms, including the trigger, if no

windowing specification is given. If windowing is selected, you are limited to

a total of four sequence terms.

The analyzer default is no sequencing terms. If you select the sequencer

using the find_sequence parameter, you must specify at least one qualifying

sequence term.

The parameters are as follows:

find_sequence

Specifies that you want to use the analysis sequencer. You must enter at least

one qualifier.

Specifies the address, data, status, or executed address value or value range

that will satisfy this sequence term if looking for a sequence (find_sequence),

or will restart at the beginning of the sequence (restart). See the

QUALIFIER syntax pages for further information.