Table of Contents
Advertisement
Emulator/Analyzer Interface Commands
copy memory
copy memory
This command copies the contents of a memory location or series of locations
to the specified output.
The memory contents are copied in the same format as specified in the last
display memory command.
Contents of memory can be displayed if program runs are not restricted to
real-time. Memory contents are listed as an asterisk (*) under the following
conditions:
•
The address refers to guarded memory.
•
Runs are restricted to real-time, the emulator is running a user
program, and the address is located in user memory.
Values in emulation memory can always be displayed.
Initial values are the same as those specified by the command display
memory 0 blocked bytes offset_by 0.
Defaults are to values specified in the previous display memory command.
354
Advertisement
Table of Contents
