Table of Contents
Advertisement
To stop a trace measurement
•
Choose Trace→Stop.
•
Using the command line, enter:
stop_trace
You must use this command to stop a trace started with a Trace→Until
Stop command (refer to "To trace activity leading up to a program halt" later
in this chapter). Several other conditions may occur that will make you want
to stop a trace. The analyzer may not record any trace states because your
trigger specification isn't correct, or because you have a target system
problem. At other times, a valid trace may be capturing data slowly. You can
use the stop_trace command to prevent the analyzer from storing additional
data.
You do not have to stop a trace in order to begin viewing a partial trace
because the interface supports incremental trace uploading. After the trigger
condition occurs, the interface begins uploading and displaying trace states
as they are captured.
To display the trace list
•
Choose Trace→Display or Display→Trace.
•
Using the command line, enter the display trace command.
You can display captured trace data with the display trace command. The
available options to the display trace command are described in the
"Modifying the Trace Display" section later in this chapter.
Using the Emulation Analyzer
To stop a trace measurement
197
Advertisement
Table of Contents
