Quick Settings; Frequency Range - Keysight N9923A FieldFox User Manual

Quick Settings Table
Both CAT and NA Modes allow you to view and change most relevant settings from a
single location. All of these settings are discussed in this chapter and, unless
otherwise noted, ALL of these settings can also be made using the standard softkey
menus.
How to view and change Quick Settings
 Press Meas Setup 4.
 Then Settings.
 Press
 To change a setting:
 Press
 When finished changing ALL settings, press

Frequency Range

Set the range of frequencies over which you would like to make CAT Mode
measurements.
When the frequency range is changed after a calibration is performed, the cal
becomes interpolated. Learn more on page 62.
How to set Frequency Range
 Press Freq/Dist .
 Then choose from the following:
 Follow each setting by entering a value using the numeric keypad, ▲|▼ arrows,
46
and
Next Page Previous Page
NOT available, then all available settings fit on one page.
Use the ▲|▼ arrows to highlight a setting.
o
Then press Edit. The current setting changes to
o
Some settings require you to press a softkey to change the value. Otherwise, use
o
the numeric keypad, ▲|▼ arrows, or rotary knob to change the value.
When finished changing a value, press
o
to relocate the Settings table to a position relative to the
Dock Window
trace window. The Dock Window setting persists through a Preset. Choose from
the following:
Full (Default setting) Only the Settings table is shown on the screen. The trace
o
window is temporarily not shown.
Left The Settings table is shown to the left of the trace window.
o
Bottom The Settings table is shown below the trace window.
o
and frequencies - beginning and end of the sweep.
Start Stop
o
and
Center Freq Span
o
frequencies (half on either side of center).
or the rotary knob.
After using the keypad, select a multiplier key. Learn about multiplier
o
abbreviations on page 19.
to view all settings. If these softkeys are
Done Edit.
Done
frequencies – the center frequency and span of
yellow.
to save your settings.
FieldFox User's Guide