Keysight N9923A FieldFox User Manual page 24

A 3-trace configuration. Tr2 is the ACTIVE trace as indicated by the highlighted
Trace Setting Notes
 The Frequency Range, IF BW, Resolution, Average, and Output Power settings are
 All other trace settings, such as measurement, format, and limit lines, are applied
 By default, a marker is created on ALL traces as shown in the above image.
How to select a multi-trace configuration
 Press Trace 6
 Then
 Then choose from the following:
 How to activate a trace in order to change a setting
 Use the ▲|▼ arrows OR
 Press Trace 6 then select
24
common for all displayed traces.
individually to the ACTIVE trace in the same manner as when a single trace is
present.
However, they can be created individually by disabling Coupled Markers. Learn
more on page 112.
Num Traces
Default measurements depend on the options that are installed.
1 trace standard configuration
x1
2 traces overlayed on a single graticule
x2
2 traces on separate horizontal graticules
x2H
3 traces on separate horizontal graticules
x3H
3 traces overlayed on a single graticule
X3
4 traces on separate graticules
x4
that are shown can be activated.
Trace 1, Trace 2, Trace
Tr 2
3, or 4, Only traces
Trace
FieldFox User's Guide