Initial Start-Up - Procedure For Proper Assembly; Install Power Supply - Sirona SIROLaser Xtend Operating Instructions Manual

Table of Contents

Advertisement

4 Installation
4.4 Initial start-up – procedure for proper assembly
24
Initial start-up – procedure for proper assembly
4.4
Any national or local regulations stipulating that the SIROLaser Xtend
may be installed only by trained personnel must be strictly observed.

1. Install power supply

2. Assemble handpiece, optical fiber and single-use tip
3. Install remote interlock – optional
4. Start SIROLaser Xtend for the first time
4.4.1
Install power supply
1. Connect the power cable to the DC IN socket at the back of the
SIROLaser Xtend.
2. Please make sure to switch on the switching power supply.
Ä The green LED on the power supply lights up.
CAUTION
The SIROLaser Xtend may only be operated with the Sinpro
MPU100-106 power supply. Operation with other power supplies may
result in failure or destruction of the laser unit. If any power supply
other than the one recommended is used, the approval of the entire
unit automatically becomes void and the warranty granted by Sirona
Dental Systems GmbH expires.
The use of any power supplies other than the one recommended may
cause overheating and failure of the laser unit or damage of batteries.
The SIROLaser Xtend can be equipped with a rechargeable battery to
allow operation without a connected power cable.
NOTE
For mounting the battery, please see "Replacing the rechargeable
battery of the control unit"  [→ 67].
The status of the rechargeable battery and whether the power cable is
actually connected will be always displayed on the touch screen.
NOTE
There will be a warning if the rechargeable battery will reach a low
level of capacity.
The SIROLaser Xtend is fully functional and can be run while charging
the battery.
➢ Charge the battery completely.
NOTE
The rechargeable battery must be fully charged regularly. After six
months of non-charging the rechargeable battery might reduce its
loading capacity.
Sirona Dental Systems GmbH
Operating Instructions SIROLaser Xtend
63 18 351 D3576
D3576.201.01.05.02    11.2018

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents