Table of Contents
Advertisement
Sirona Dental Systems GmbH
Operating Instructions SIROLaser Xtend
Accessories
Tissue particles
Location
Set up
63 18 351 D3576
D3576.201.01.05.02 11.2018
Contamination
2.10
Danger of (cross) contamination. Pay attention not to hurt or stick
yourself or any other person with the laser fiber or the tip. This applies
also, if the handpiece is placed in the holder.
Prior to each use, the handpiece sleeve and the optical fibers must be
sterilized.
By cutting and coagulation of tissue, tissue particles could get into the
air. Always wear a face mask, because a risk of infection exists.
A extractor or a filter should be used. The operating personnel should
be aware that biologically active material could get into the enviroment.
It may contain particles of viable tissue.
Installation
2.11
The SIROLaser Xtend is to be protected against the intrusion of liquids.
The SIROLaser Xtend must not be used in areas, in which the
appearance of liquids is probable.
Verify that the line voltage corresponds to the voltage indicated on the
rating plate of the power supply or in the technical specifications.
Do not place the unit near heat sources. Do not cover the convection
openings for air cooling on the sides of the unit.
Make sure that the electrical system is equipped with the required
devices for protection against direct and indirect contact
(thermomagnetic switches, residual current circuit breakers) and has
been set up by a qualified electrician in compliance with the applicable
standards.
Avoid interference between the laser emission and any optical sensors
of devices operated in the vicinity of the SIROLaser Xtend.
National directives regarding electrical installations must be observed.
Set up the SIROLaser Xtend unit properly and completely before putting
it into operation, see chapter "Installation" [→ 22].
2 Safety information
2.10 Contamination
11
Hide quick links:
Advertisement
Table of Contents
