Troubleshooting Of Simple Defects - Sirona SIROLaser Xtend Operating Instructions Manual

Sirona Dental Systems GmbH
Operating Instructions SIROLaser Xtend
General
Finger switch
Optical fiber
Aiming beam
63 18 351 D3576
D3576.201.01.05.02 11.2018
The manufacturer accepts responsibility for the safety of the laser unit
only if the following requirements are fulfilled:
● Modifications of the laser unit or repair work may be performed only
by authorized personnel.
● The electrical installations in the rooms where the SIROLaser Xtend
is used must fulfill the applicable legal requirements.
● The unit must be used in compliance with the instructions provided
in the present manual.
8.3

Troubleshooting of simple defects

In case of malfunctioning, proceed as follows:
First general directions in case of malfunctioning:
● Check if power supply is connected properly and/or rechargeable
battery is loaded.
● Check if fiber is installed correctly.
● Be sure that all operational steps have been carried out correctly.
● Check the functioning of the finger switch by pressing several times.
The touch screen of the SIROLaser Xtend remains dark after switching
it on.
● Check the connection of the power cable and/or check the
rechargeable battery.
● Make sure that the switch on the switching power supply is switched
on.
● Check the connection of the interlock device.
The finger switch is claimed to be missing.
● Check if the plug of the cable is properly connected to the control
unit.
The fiber is claimed to be missing.
● Make a visual check of the optical fiber and its connector. If you see
any damage (e.g. scratches) replace the optical fiber with a new
one.
● Check the connection of the optical fiber.
● Check the proper assembly of the handpiece sleeve.
● Be sure that all operational steps have been carried out correctly.
There is no aiming beam.
● Check to see if the optical fiber or its connector is damaged. If the
optical fiber is damaged, replace it with a new one.
● Check the connection of the optical fiber.
● Check the proper assembly of the handpiece sleeve.
● Be sure that all operational steps have been carried out correctly.
The light of the aiming beam does not project a uniform circular pattern.
● Trim the end of the optical fiber with the fiber cutter again. Always
make the notch perpendicular to the optical fiber.
8 Maintenance and service
8.3 Troubleshooting of simple defects
65