Making A Bend In The Conductor Rail - Conductix-Wampfler SingleFlexLine Program 0815 Operating Instructions Manual

Operating Instructions
Single-pole conductor-rail system
SingleFlexLine Program 0815
6.3.2.2

Making a bend in the conductor rail

Conductor-rail bends can be fabricated in the factory or on site. They are prepared using the bending device 081091. For large
installations, electrically driven bending devices available upon request.
Fig. 24: Outside/inside bends and horizontal bend
Use of bends in horizontal and vertical curves
Horizontal curve
Vertical curve
BAL0815-0002d-US
www.conductix.us
Read and respect the additional operating instructions!
You can find additional information on the making a bend in a conductor rail in BAL0800-0004.
Engagement direction of the current collector
Vertical (from below)
Horizontal curve
suspension interval: 400 mm
bend radius: 1000 mm to ∞
Internal/external bend
suspension interval: 250 mm
Bend radius: 450 mm to ∞
Horizontal (from the side)
Internal/external bend
suspension interval: 250 mm
bend radius: 450 mm to ∞
Horizontal curve
suspension interval: 400 mm
bend radius: 1000 mm to ∞
translated document
Item Name
1 Inside bend
2 Outside bend
3 Horizontal bend
page 40 of 94