Conductix-Wampfler SingleFlexLine Program 0815 Operating Instructions Manual page 34

Operating Instructions
Single-pole conductor-rail system
SingleFlexLine Program 0815
DANGER!
DANGER!
DANGER!
BAL0815-0002d-US
www.conductix.us
Risk of injury by crushing skin and limbs!
There is a danger of crushing of skin and limbs due to:
Spring force/gravity (stored energy)

Current collector (spring force) during installation, dismantling and maintenance

Falling conductor-rail system components if they have not been properly installed or if oper-

ated in inappropriate operating conditions (e.g. environment that contains solvents)
→ Have installation done only by trained technicians
→ When working on the conductor-rail system, wear safety boots, safety gloves, and a safety
helmet
→ When changing the collector brush, follow the separate instructions for this task. See
chapter 12.1
→ Only install the conductor-rail system where suitable operating conditions prevail. See
chapter 3.3
Risk of injury due to grasping or impact!
Grasping and/or impact with moving conductor-rails (slip ring) or current collectors con-
nected to the machine and other components must be prevented.
→ Cordon off the work area
→ Caution when working in the vicinity of the danger zone, in particular if protective devices
(covers, enclosures, control devices) have been removed or disabled
→ Caution when working in the vicinity of the danger zone, in particular below the conductor-
rail
→ Falling conductor-rail system components if they have not been properly installed or if op-
erated in inappropriate operating conditions (e.g. environment that contains solvents)
→ Use personal protective equipment!
Risk of injury from cuts and cutting!
Cuts and amputations can occur:
on sharp edges of the general components

on sharp edges of the conductor-rails

on cut edges when trimming the conductor-rails

on packaging materials (cartons, tapes, etc.)

→ Use personal protective equipment!
translated document page 34 of 94