Assembly; Safety - Conductix-Wampfler SingleFlexLine Program 0815 Operating Instructions Manual

Operating Instructions
Single-pole conductor-rail system
SingleFlexLine Program 0815

6 Assembly

6.1 Safety

Installation and initial commissioning may only be carried out by specially trained technicians.

Required protective equipment:
WARNING!
DANGER!
DANGER!
BAL0815-0002d-US
www.conductix.us
Risk of death due to suspended loads!
Falling loads can lead to severe injuries or even death.
→ Never walk under suspended loads.
→ Only move loads under supervision.
→ Set down the load when leaving the workplace.
→ Use personal protective equipment!
Injury due to improper installation and initial commissioning!
Improper installation and initial commissioning can result in serious injury to persons and/or
material damage.
→ Before starting work, make sure there is sufficient space for assembly.
→ Handle open, sharp-edged components carefully
→ Make sure the installation area is tidy and clean! Loosely stacked or scattered components
and tools are a source of hazards
→ Install components properly. Comply with the specified screw tightening torques
Poisonous gases in case of fire!
In case of fire in the facility, the plastic parts (PVC) of the conductor-rail system emit poisonous
gases (HCL).
→ The system operator must take this into account accordingly when planning and take the ap-
propriate protective measures
→ The building must be evacuated immediately.
→ The fire brigade must be informed.
translated document page 33 of 94