Table of Contents
Advertisement
Figure 129. Removing the right control panel
Next steps
1.
Replace the right control
Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
Steps
1. Route the right control panel cable and the VGA cable through the chassis sidewall.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the tabs on the right control panel assembly into the slots on the chassis.
3. Using a Phillips #1 screwdriver, replace the screws to secure the right control panel assembly to the chassis.
4. Connect the right control panel cable to the connector on the system board.
panel.
Safety instructions
Before working inside your system
on page 43.
on page 44.
Installing and removing system components
141
Advertisement
Table of Contents
