Figure 51. Removing the rear drive backplane
Next steps
Install the rear drive
backplane.
Installing the rear drive backplane
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove all the drives from the rear drive cage.
4. Disconnect all the cables from the backplane.
5.
Remove the rear drive
cage.
Steps
1. Align the slots on the backplane with the hooks on the rear drive cage.
2. Lower the backplane into the rear drive cage until it is firmly seated.
3. Using a Phillips #2 screwdriver, tighten the screws to secure the backplane to the rear drive cage.
Safety instructions
on page 43.
Before working inside your system
on page 44.
Installing and removing system components
71