Table of Contents
Advertisement
Figure 100. Removing the cable cover
2. Lift open the cable latch and disconnect the control panel cable from the connector on the system board.
NOTE:
Observe the routing of the cable as you remove it from the system.
3. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel assembly.
4. Hold the right control panel assembly and remove it from the system.
Figure 101. Removing the right control panel
Next steps
Replace the right control
panel.
Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
110
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
