Installing The Right Control Panel - Dell EMC PowerEdge R7525 Installation And Service Manual

Figure 24. Removing the right control panel
Next steps
1. Replace the right control

Installing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Align and slide the right control panel in the slot on the system.
2. Connect the right control panel cable and VGA cable to the connectors on the system board.
3. Route the right control panel cable through the side wall of the system. Align and slide the right control panel cable cover in
the slot on the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel and the right control panel cable
cover to the system.
34 Installing and removing system components
panel.
Safety instructions
Before working inside your system
on page 26.
on page 27.