Table of Contents
Advertisement
Figure 129. Removing right control panel
Holding by the sides, remove the right control panel away from the system.
Holding the control panel by its sides, remove the control panel away from the system.
Next steps
Install the right control panel.
Installing the right control panel
Prerequisites
Follow the safety guidelines listed in
Steps
Route the control panel cable through the side wall of the system.
Align the right control panel assembly with the control panel slot on the system.
Connect the control panel cable to the connector on the system board and lower the cable latch to secure the cable in place.
Using a Phillips #1 screwdriver, install the screw that secures the control panel to the system.
Figure 130. Installing the right control panel
Using a Phillips #1 screwdriver, install the screws that secure the cable cover to the system.
166
Installing and removing system components
Safety
instructions.
Advertisement
Table of Contents
