Table of Contents
Advertisement
Figure 170. Removing right control panel
Next steps
Install the right control panel.
Installing the right control panel
Prerequisites
Follow the safety guidelines listed in
Safety
instructions.
Steps
1. Route the control panel cable and VGA cable through the side wall of the system.
2. Align the control panel with the control panel slot on the system and attach the control panel to the system.
3. Connect the VGA cable to the system board.
4. Connect the control panel cable to the connector on the system board and lower the cable latch to secure the cable in place.
5. Using a Phillips #1 screwdriver, install the screw that secures the control panel and cable tube to the system.
Installing and removing system components
207
Advertisement
Table of Contents
