System Health And System Id Indicator Codes; Idrac Quick Sync 2 Indicator Codes - Dell EMC PowerEdge R7515 Installation And Service Manual

Table 72. Status LED indicators and descriptions (continued)
Icon Description
Electrical indicator The indicator turns solid amber if the
Memory indicator
PCIe indicator

System health and system ID indicator codes

The system health and system ID indicator is located on the left control panel of the system.
Figure 134. System health and system ID indicator
Table 73. System health and system ID indicator codes
System health and system ID
indicator code
Solid blue
Blinking blue
Solid amber
Blinking amber

iDRAC Quick Sync 2 indicator codes

iDRAC Quick Sync 2 module (optional) is located on the left control panel of the system.
Condition
system experiences an electrical error
(for example, voltage out of range, or
a failed power supply unit (PSU) or
voltage regulator).
The indicator turns solid amber if a
memory error occurs.
The indicator turns solid amber if a
PCIe card experiences an error.
Condition
Indicates that the system is powered on, is healthy, and system ID mode is not active. Press
the system health and system ID button to switch to system ID mode.
Indicates that the system ID mode is active. Press the system health and system ID button to
switch to system health mode.
Indicates that the system is in fail-safe mode. If the problem persists, see the Getting help
section.
Indicates that the system is experiencing a fault. Check the System Event Log for specific
error messages. For information about the event and error messages generated by the
system firmware and agents that monitor system components, go to
> Error Code, type the error code, and then click Look it up.
Corrective action
Check the System Event Log or system messages for
the specific issue. If it is due to a problem with the PSU,
check the LED on the PSU. Reseat the PSU.
If the problem persists, see the
Check the System Event Log or system messages for
the location of the failed memory. Reseat the memory
module.
If the problem persists, see the
Restart the system. Update any required drivers for the
PCIe card. Reinstall the card.
If the problem persists, see the
NOTE: For more information about the
supported PCIe cards, see the Expansion card
installation guidelines section.
System diagnostics and indicator codes
Getting help section.
Getting help section.
Getting help section.
qrl.dell.com > Look Up
159