Figure 38. Removing a drive blank
Next steps
1.
Install a drive or replace the drive
Installing the drive blank
Prerequisites
1. Follow the safety guidelines listed in the
2. If installed,
remove the front
Steps
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 39. Installing the drive blank
Next steps
1.
Install the front
bezel.
Removing the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
2. Using the management software, prepare the drive for removal.
If the drive is online, the green activity or fault indicator flashes while the drive is turning off. When the drive indicators are off, the
drive is ready for removal. For more information, see the documentation for the storage controller.
62
Installing and removing system components
blank.
Safety instructions
bezel.
Safety instructions
on page 43.
on page 43.