Table of Contents
Advertisement
Figure 95. Installing the M.2 SSD module
Next steps
1.
Install the BOSS card
into the riser.
NOTE:
The procedure to install the BOSS card is similar to removing an expansion card.
2.
Install expansion card riser
3.
Install the air
shroud.
4. Follow the procedure listed in
Optional IDSDM module
Removing the IDSDM card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If you are replacing the IDSDM card,
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards
into the corresponding slots.
Steps
Holding the pull tab, lift the IDSDM card out of the system.
NOTE:
There are two dip switches on the IDSDM card for write-protection.
After working inside your system
Safety instructions
Before working inside your system
remove the MicroSD
on page 44.
on page 43.
on page 44.
cards.
Installing and removing system components
109
Advertisement
Table of Contents
