Table of Contents
Advertisement
Figure 107. Installing the mini PERC card air shroud
Next steps
1. If removed,
replace the expansion card
2. If removed,
replace the rear drive
3.
Install the air
shroud.
4. Follow the procedure listed in
Removing the internal mini PERC card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If applicable,
remove the rear drive
5. If applicable,
remove the expansion card
6.
Remove the PERC card air
Steps
1. Disconnect the SAS connector from the backplane.
2. Using a Phillips #1 screwdriver , remove the screws securing the internal mini PERC card.
3. Lift the internal mini PERC card at an angle to disengage it from the PERC slot and remove it from the system.
riser.
cage.
After working inside your system
Safety instructions
Before working inside your system
cage.
riser.
shroud.
on page 44.
on page 43.
on page 44.
Installing and removing system components
119
Advertisement
Table of Contents
